Sewer JetterMJ-8000

High-pressure jetting clears a blocked line and flushes the debris out of it, rather than just pushing the blockage further down the pipe. The MJ-8000's 267 LPM / 150 bar triplex plunger pump, driven by a full-torque split-shaft PTO off the vehicle's gearbox, forces water through a 25mm x 60m hose and a self-propelled nozzle that pulls itself forward through the line, breaking up the blockage and flushing debris ahead of it. Its high flow is built for the largest trunk lines in the MJ-series range, while maintaining constant pressure at the nozzle regardless of hose length. A hydraulically wound hose reel and an additional hand-held washing gun for equipment, vehicle, and general high-pressure washing round out the unit.

Every MJ-series sewer jetter ships standard with two nozzle types:

• Conical Head Nozzle (front and rear holes) — a general-purpose nozzle that balances forward penetration with rear thrust to pull the hose through the line
• Round Head Nozzle (front and rear holes) — a wider spray pattern for flushing loosened debris out of the line

Additional nozzle types can be supplied to match specific jetting jobs, including:

• Penetrator Nozzle — forward and rear jets to punch through grease plugs and tough blockages before flushing
• Root Cutter Nozzle — carries small cutting blades driven by the water jets to shred root intrusions
• Flusher / Descaling Nozzle — flailing chains or carbide tips to scour hardened scale and mineral buildup from pipe walls
• Rotating Nozzle — spins under pressure for 360° wall cleaning, effective on grease and light debris

• Large trunk lines from about 750/1000mm up to 1500mm (30-60 inches) in diameter
• Major municipal infrastructure and large industrial sites
• Crews that want a hose counter to track footage fed into the line