Get Your Free Quote…!
Compact articulating boom for lifting into tight, obstructed spaces.
View Details →
The TM-JSR3000 is a 3-in-1 multi-function sewer cleaner mounted on an 11-ton chassis, combining high-pressure jetting, vacuum suction, and mechanical rodding in a single unit — cutting down on the number of separate machines a crew needs to keep on hand.
Page last updated: September 9, 2026
Jetting: a 137 LPM / 140 bar triplex plunger pump, driven by a full-torque split-shaft PTO, forces water through a 3/4" x 60m hose and a self-propelled nozzle that pulls itself forward through the line, breaking up blockages and flushing debris out ahead of it.
Suction: a 390 cum/hr vacuum pump generates high vacuum in the sludge tank to siphon effluent, liquids, and settled sludge through a 3" x 15m hose. A sludge stirring arrangement converts solid silt into a slurry the pump can draw up, and a blow-back system discharges just the water content of the tank so the load carries away the sludge without hauling unwanted water weight.
Rodding: a trolley-mounted rodding machine screws flexible steel rods end to end and guides them into the line, then pushes the rod forward and pulls it back to break up the clog mechanically — effective where jetting alone can't clear a hard obstruction.
A trolley-mounted sewer rodding machine works alongside the jetting and suction systems to clear blockages mechanically. Several flexible 7mm x 1m steel rods are screwed end to end and guided into the line, then pushed forward and pulled back to break up the clog.
Every 3-in-1 multi-function sewer cleaner ships standard with two nozzle types:
Additional nozzle types can be supplied to match specific jetting jobs, including penetrators, root cutters, descaling nozzles, and rotating nozzles.
Enter your details below and we'll email you the complete specification sheet for this model, along with a photo so you know exactly which unit you're looking at.
High-pressure jetting, vacuum suction, and mechanical rodding, all on one 11-ton chassis.
Both options are available — a 5Hp air-cooled diesel engine or an AC electric motor, so you can choose based on power access at the job site.
A rod guide pipe, push/pull-out tool, pick-up tools in 1.5" and 2" sizes, cork screws (25/40/50mm), and a bar turning handle, in addition to the 30 flexible 7mm x 1m cleaning rods supplied with the machine.
From about 450 to 500mm (18-20 inches) in diameter, using its 137 LPM / 140 bar jetting pump.
